I’m new to elua and scripting language. I wonder anyone can advise me on the below.
-Does Omnima STM32 Expander comes with elua pre-loaded image? If not, how do I pre-loaded the elua to start programming?
-Does Omnima STM32 Expander comes with pre-installed elua library? If yes, any additional info on how to use it?
- Is there a special file location that I need to place a elua written source programs so that to execute it even when board is powered-up? Do we have to write a batch file using Make command?
-How to burn/jtag a elua file written in notepad eg xxx.elua into the STM32 Expander? What is the command?
Thks & rgds,
Tan Whee Min | Development Engineer
Tel: 65-65500583 Fax: 65-64520400 | [hidden email] | www.nyp.edu.sg